iGET SECURITY P12 - Outdoor Solar Siren

Note:
The iGET SECURITY P12 is not compatible with the iGET SECURITY M2B alarm model with serial numbers starting with M2B20131220xxxx! It is fully compatible with all other serial numbers! Please note: additional information is provided in the "Notes/Limitations" section below!

P12
Outdoor Solar Siren This is an outdoor solar siren designed for installation on a house, garage, cottage, etc. It is intended for use with the iGET SECURITY M3B and M2B alarms. This siren is compatible only with alarms from other brands that support the 433 MHz siren frequency band!

Key specifications:

• The outdoor solar siren is designed for all locations where it is appropriate to trigger an outdoor alarm
• unlike standard sirens, it does not require power from a 230V AC adapter, which is very difficult to install at a sufficient height on a house
• During an alarm, it emits a 110 dB emergency tone, and bright red LEDs on the device also light up
• It features a rear security iron bracket, meaning that if the siren is accidentally removed, it will immediately trigger an alarm
• The siren is continuously powered by a solar panel; the backup battery can sustain multiple alarms, meaning the siren remains active
• Simple expansion of the basic alarm set
• Truly robust construction that is very well sealed against water ingress and withstands weather conditions

Note/Limitation:
The siren responds immediately, without delay. It cannot be used with a delayed alarm setting.
When using this siren, the alarm must be controlled via key fobs, meaning activation/deactivation occurs immediately.
Therefore, it cannot be used with a delayed detection zone, as the alarm is triggered immediately, not after the countdown for code entry has ended.

Descriptions and specifications are for informational purposes only and are subject to change without prior notice.